- 商品详情
- 商品规格
博辰公司2016年返利优惠政策
尊敬的各位客户，为了感谢大家一直以来的支持，博辰公司特意做出2016年销售返利活动，返利的具体详情如下:
活动参与产品:万邑链平台上归属博辰公司的所有一切产品。
1、月销售额达5000-20000人民币，次月返利2%的现金在对应的万邑链分销帐号。
2、月销售额达20000-50000人民币，次月返利3%的现金在对应的万邑链分销帐号。
3、月销售额达50000人民币以上，次月返利5%的现金在对应的万邑链分销帐号。
备注:返利充值的现金不能提现使用，只能限制消费博辰公司归属的产品。活动一切解释权归博辰汽配用品公司所有。
Description:
The scissor jack, with tooth gears, can extend from 85mm(close position) to 330mm, more than enough to lift most vehicles. Easy to operate using the chromed crank with speed handle.
Specifications
Color: Red
Minimum height: about 85MM
Maximum height: approximately 330MM
Lifting: 1T
Color: Red
Material: Steel
Net weight: 1.85KG
Item Size: 35.5*8.2*8.5CM
Package included:
1 x SCISSOR JACK
产品包装后尺寸:41*10*9(CM)
产品包装后重量:1.9KG
WARNING
1. Study, understand and follow all instructions before operating this device.
2. Do not exceed rated capacity as designated by the height/capacity curve.(Sea below)
3. Use only on hard level surface.
4. Use for emergency tire changing only.
5. Never get beneath the vehicle when it is supported by the jack.
6. Activate the hazard warning flasher, turn off ignition, set parking brake, move automatic shift selector to park position. In case of a manual transmission, move gear selector into reverse position. In addition, the wheel diagonally opposite from the wheel being lifted shall be chocked in both directions.
7. Lift only on areas of the vehicle as specified by the vehicle manufacturer.
8. Follow tire changing procedure as per the vehicle manufacturer's owner's manual.
9. No alterations shall be made to this product.
10. Failure to heed these messages may result in personal injury and/or property damage.
HEIGHT/CAPACITY CURVE
This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position.
Before Use
1. Check before each use for abnormal conditions such as cracked welds, leaks, damaged, loose or missing parts.
2. Inspect the jack immediately if lift is believed to have been subjected to an abnormal load or shock.
3. If the jack is found to be damaged, it should be removed from service until properly repaired.
OPERATING INSTRUCTIONS
1. Insert the jack handle into the hole of the handle socket.
2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket.
3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise.
4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly.
CARE AND MAINTENANCE
1. When jack is not in use, lifting arm should be in full down position.
2. Always keep jack clean and keep the screw and bearings well lubricated.
3. Store the handle with care.
登录后可查看全部 / 去登录
